[Ferdi]

bitte sehr .

hab noch was interessantes über "Adaptionsspeicher" entleeren gefunden .
http://www.mini2.com/forum/showthread.ph...hlight=MTH

In order to reset the ecu follow the procedure below

1) With the key in the off position press and hold the speedo reset button, turn the key to position one and the screen will say test and a number.

2) Go through the list by pressing the reset button upto test 19 and then wait.

3) The display should then say"log i-off" then "log i-on" over and over again....when "log i- off" appears again press the reset button ....and now you are in the system software.

4) Scroll upto 21.0 Software reset. When reset appears press the button again and you will get a beep and you're speedo needle may vibrate a little (this is normal).

5) Turn ignition off then back on to position 2 for 10 secs then start your car and hey presto its done.

This clears out all the information about your driving style etc, driving the car hard after doing this reloads the ecu memory with a hard driving style which ensures that throttle response etc remains sharp and helps the map to evolve to its best potential