19.11.2012, 13:50
Hast du für den CAN Bus Grün und Weiß verwendet? Verkabelung in Ordnung? Schlechter Kontakt?
Dip Schalter VOR dem Einbau richtig gesetzt? (alle unten?)
Rest Unika: "In case of problem or if you have installed the UNIKA interface in another
car, reset the UNIKA by holding down the Reset button until the LED turns
off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (resistive
protocol). You can then release the reset button."
Wenn das alles nichts hilft, es gibt sonst noch ein Firmwareupdate für die Unika und MKI siehe http://www.parrot.com/de/kundenkontakt/parrot-unika
Dip Schalter VOR dem Einbau richtig gesetzt? (alle unten?)
Rest Unika: "In case of problem or if you have installed the UNIKA interface in another
car, reset the UNIKA by holding down the Reset button until the LED turns
off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (resistive
protocol). You can then release the reset button."
Wenn das alles nichts hilft, es gibt sonst noch ein Firmwareupdate für die Unika und MKI siehe http://www.parrot.com/de/kundenkontakt/parrot-unika
instant human, just add coffee